[
]
http://www.hairdirect.com/store/Walker-Ultra-Hold-3-4Oz.aspx
ULTRA HOLD & LIQUI TAPE
Extended Wear Bonding Instructions
The following instructions below are for bonding hairpieces or wigs to skin (scalp). This method of bonding requires the bonding area to be hairless in order to secure a hairpiece or wig. Below are complete step-by-step instructions for using Walker Ultra Hold (or Mity Tite) Adhesive for securing hairpieces or wigs for wearing.
GRAFTING (100% Poly):
Clean scalp and dry.
. Use sponge or brush to apply a thin even coat of adhesive to surface of hairpiece or wig foundation and your scalp.
. Allow adhesive to dry apart until tacky (3 to 5 minutes) before bonding.
. Join two surfaces together and press and hold for 3 to 5 minutes before styling hairpiece or wig.
Avoid doing the following for 24 hours:
a. activities causing sweating.
b. do not wash hairpiece or wig... keep dry.
Bonding Lace or Mesh:
Clean scalp and dry.
. Apply Walker's Scalp Protector to lace/mesh to provide easier clean up.
. Use sponge or brush to apply 2 (two) even coats of adhesive to scalp. (Allow 3 to 5 minutes between coats.)
Allow adhesive to become tacky. Solvents must evaporate to insure secure bonding.
. Position system on head and firmly press (for 1 minute) on areas where adhesive has been applied to system.
Avoid for doing the following for 24 hours:
a. activities causing sweating.
b. do not wash hairpiece or wig... keep dry.